In English only
||||
 Topic: Piling Subject: spun pile joint plate
 Author: christian 2003-12-13 Greeting,I am carrying out piling, 350mm x12m and 450mm x12m spun pile, having installed length of 50m to 60mMy problem is maintaining the straightness of the pile to within 75mm in all directionThe diameter of the end plate against the length of the pileeg for 350mm and 450mm pile ratio of length to diameter is 34.28 and 26.66 Notable here is that if the surface of the end plate of a pile deviated from true 90 degree against the shaft of the pile by 1mm , this pile will be tilted 34.28mm or 26.66mm when a flat plate to plate welding is done between the end.in this respect, installing a 60 m installed length of pile will theorically have a deviation of 171.4mm and 133.3mm deviation.Unfortunately, I have found that each pile have such deviation of approximately average of 3mm, aggrevating the problem to 857mm or 666.5mm. Off course this is the maximum theoritical state and sue to compensating factor, it will always be less.I am in Malaysia and found that 3 such factories producing spun piles have piles of this tolerance (averaging 3mmI shall be happy to understand what is the tolerance of the piles manufacturers of others countries and what is being done in spun pile installation to keep the piles straight.Thanks anyone for an answer.Christian Reply to this posting
Follow-up:
 Author: wilson 2005-08-29 if you want do the joining,lets the pile protude as long as you can.so you can see the shaft of pile below.just make straight to the joint pile by use theodolite.tilted the theodolite follows the tilt pile under ground.you can see the line of pile.do not follow the pile head.

Follow-ups:
 Show all follow-ups